Been daily driving low-profile Gateron switches for a while but wanted to give MX another shot. Mostly so I can use my nice keycaps again. I didn’t buy this filament specifically for this build but I think it works really nicely.

Switches are Ergo Clears, lubed and filmed with (IIRC) 45g springs. They were previously on an Ergodox and barely got any use as I switched to smaller boards shortly after modding them and wasn’t comfortable with desoldering yet, so I’m happy to have finally found a new home for them.

Caps are MT3 Godspeed, case is Overture Matte PLA (light blue and white), printed on the Sovol SV06 Plus.

  • DeltaWhy@lemmy.worldOP
    link
    fedilink
    English
    arrow-up
    2
    ·
    9 months ago

    I’ve only been using it for a day so I’m still figuring that out. Something about it feels a bit ‘off’ compared to my Elecom Deft Pro but I’m not sure if that’s a hardware or software issue - could just be a smaller ball is harder to get the same accuracy, could be the cheap BTUs I’m using. I’ll probably try printing a different trackball holder that uses static bearings to see if I prefer that.